Top best answers to the question «How to make gold jewelry pendants»
How do you make a wire wrapped pendant?
- With the 4 inch wrap wire, start wrapping the two section of wire together at the uppermost pen mark, wrapping upwards. Make about three complete wraps. NOTE: Do not clip off the wrap wire. Next, using your hands, bend the two rear wires of each side of the bundle backwards. These will be your bail wires.
9 other answers
Hi, everybody. Today I will show you how to make a pendant, a Slavic amulet, from 14k gold.Used 14k white and red gold.Sun pendant -----...
DIY faux gold dipped jewelry is all the rage so this tutorial is exactly what you need to make beautiful DIY jewelry. It's a quick and versatile project that...
How to Make a Gold Filled Bezel Pendant
Let the wax mold sit until the gold hardens, usually between 45 minutes to an hour. Place the mold in a press or clamp or under a heavy object to keep both halves tightly pressed together. Step 8 Open the mold and remove the jewelry.
OPEN TO FIND RESOURCES AND LINKS! How to make gold filled jewelry - today I will share with you some basics of working with gold filled metal! Enjoy watching...
Cut four 6 inch lengths of 21 gauge Gold-filled square half hard wire. Cut one wrap wire 2 inches long and cut another wrap wire 4 inches long, both from 21 gauge Gold-filled square half hard wire. Make a flat bundle with the four 6 inch wires and mark the center of the bundle with a Sharpie pen.
If you are ready to learn how to make a pendant, we have collected some of the best DIY jewelry tutorials for you. They are categorized into beaded jewelry tutorials , wire wrapped jewelry , jewelry made with stones, and a collection of just unique DIY pendants you just have to see.
Remember that the higher the gauge of your sheet metal, the thinner the metal will be. Therefore, 22-gauge sheet metal will be heavier than 28 gauge. To be creative, suspend your pendant from a strip of leather, a ribbon or a silk cord rather than a traditional chain.
Apply a big dollop of Fantastic Glaza and Glue on the back of the glass piece. You want the glue to ooze out along the edges so you get a good seal. Then just wipe the excess away with a q-tip. After the glue is nice and dry, cut it out along the glass edges using a pair of scissors.